LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1077 (Engine) >> In-Vehicle Repair >> Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER .
    2. NOTE: Mark the positions of the hydraulic lash adjusters to make sure they are assembled in their original positions.
  2. Remove the hydraulic lash adjusters.
    3. NOTE: Inspect the hydraulic lash adjusters for scoring marks and uneven wear in the bore. Install new lash adjusters if necessary.
  3. To install, reverse the removal procedure.
    • Lubricate the hydraulic lash adjusters with clean engine oil.
scientia non olet · About LEMON Manuals