LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Air Bag Restraint Systems) >> Removal & Installation >> Steering Wheel >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: A sudden impact could damage bearing or collapse steering column. Steering column malfunction or failure may result. When removing steering wheel, do not use a knock-off type steering wheel puller, or strike steering wheel or shaft with a hammer.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Ensure front wheels are in straight-ahead position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE .
  2. Loosen steering wheel mounting bolt several turns. Mark steering wheel hub and steering shaft for reassembly reference. Using 2-Jaw Puller (205-116/T77F-4220-B1) or equivalent, pull steering wheel from steering shaft. Remove and discard steering wheel retaining bolt. Route clockspring wiring harness through steering wheel as wheel is lifted from steering shaft.
  3. To install, reverse removal procedure. Install NEW steering wheel mounting bolt and tighten to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals