LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Air Bag Restraint Systems) >> Removal & Installation >> Belt & Buckle Assembly PRETENSIONER >> Removal

Belt & Buckle Assembly PRETENSIONER: Removal

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Belt and buckle assembly pretensioners are located at lower inboard sides of front seats. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. On left-side pretensioner, remove front seat back latch lower cover. On right-side pretensioner, remove front seat back pivot side outer cover. Disconnect belt and buckle assembly pretensioner harness connector. Using Seat Belt Bolt Bit (501-010 or T77L-2100-A) or T-50 Torx tool, remove belt and buckle pretensioner retaining bolt and pretensioner.
scientia non olet · About LEMON Manuals