LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Air Bag Restraint Systems) >> Disabling & Activating Air Bag System >> Activating System >> Diagnostics Activating Procedure

Diagnostics Activating Procedure

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery(s). Wait at least one minute for back-up power supply to deplete stored energy. On models equipped with passenger-side air bag, remove air bag simulator from passenger-side air bag module harness connector and reconnect connector. Install passenger-side lower instrument panel finish panel, reinforcement and reinforcement bracket.
  2. Remove air bag simulator from clockspring connector. Install driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Reconnect battery cable(s). Perform system operation check. See SYSTEM OPERATION CHECK . Reprogram pre-set radio frequencies and set clock.
scientia non olet · About LEMON Manuals