LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1058 (Engine Controls - Diagnostic Methods -- 6.0L Diesel (99P F450/550)) >> On-Board Diagnostic (OBD) Drive Cycle >> Analyzing PCM Data >> Change Input and Verify Output Response

Change Input and Verify Output Response

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2005 Ford RV Cutaway, 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

The purpose is to verify how the PCM and actuator circuit respond to sensor input.

  1. Access, monitor, and record the appropriate sensor PID(s).
  2. Create the condition or cause the input condition to change.
  3. Monitor any change (response) in the actuator PID or actuator signal circuit with a measuring device.
scientia non olet · About LEMON Manuals