Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

Remove the subwoofer enclosure, if equipped.
- Disconnect the subwoofer electrical connector.
- Remove the 4 subwoofer enclosure bolt caps.
- Remove the 4 subwoofer enclosure bolts.
- Remove the subwoofer enclosure.
Remove the back of cab panel insulator.
- Remove the push pins and release the retaining clips.
- Remove the back of cab panel insulator.
Remove the D-ring bolt.
- To install, tighten to 40 Nm (30 lb-ft).
Remove the safety belt retractor bolt and the safety belt retractor.
- To install, tighten to 48 Nm (35 lb-ft).
To install, reverse the removal procedure.
Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .