LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1052 (Handles, Locks, Latches And Entry Systems -- F150 Pickup) >> Removal And Installation >> Hood Latch Release Handle - Primary >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 7 pin-type retainers and the radiator upper sight shield.
    2. NOTE: Mark the location of the hood latch with a permanent type marker.
  2. Remove the 2 hood latch bolts and position the hood latch aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  3. Disconnect the primary hood latch release cable.
  4. Remove the A-pillar lower trim panel.
  5. Remove the primary hood latch release cable screw.
    • To install, tighten to 9 Nm (80 lb-in).
  6. Release the cable locators and remove the primary hood latch release cable.
  7. To install, reverse the removal procedure.
    • When the hood latch is installed, the latch adjustment must be checked to make sure the latch is installed and aligned correctly.
    • Lubricate the hood latch after installation.
scientia non olet · About LEMON Manuals