LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1052 (Handles, Locks, Latches And Entry Systems -- F150 Pickup) >> Removal And Installation >> Door Latch Remote Control - SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The RH side is shown, the LH side is similar.
  1. Remove the rear door trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Remove the 3 upper door latch bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. Remove the 3 latch remote control assembly bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
  5. Remove the 3 lower door latch bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
  6. Release the actuating rod from the rear door interlock.
    Fig 1: Releasing Actuating Rod From Rear Door Interlock
    G03966467Courtesy of FORD MOTOR CO.
  7. Remove the latch remote control assembly.
  8. To install, reverse the removal procedure.
    • Lubricate the upper and lower rear door latches after installation.
scientia non olet · About LEMON Manuals