Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

Fig 1: Identifying Daytime Running Lamps (DRL) Resistor

Courtesy of FORD MOTOR CO.

Remove the radiator side air deflector.
- Remove the pin-type retainer.
Disconnect the daytime running lamps (DRL) resistor electrical connector.
Remove the DRL resistor bolt and the DRL resistor.
- To install, tighten to 5 Nm (44 lb-in).
To install, reverse the removal procedure.