Possible Causes

A short to battery or ignition in left seat belt pretensioner circuit could be caused by short to battery or ignition in Yellow/Red wire (circuit No. 1081), short to battery or ignition in Yellow/Black wire (circuit No. 1082), short to battery or ignition in right seat belt pretensioner, or RCM internal fault.

1. Check for hard or intermittent DTCs
   
   Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). See USING SCAN TOOL  under DIAGNOSTICS. Turn ignition switch to RUN position. Retrieve and record any continuous DTCs. See RETRIEVING FAULT CODES  . Clear continuous DTCs. See CLEARING FAULT CODES  under DIAGNOSTICS. Perform on-demand self-test. See ON-DEMAND SELF-TEST  under DIAGNOSTICS. If DTC B1882 was retrieved during on-demand self-test, fault is hard. Go to next step. If DTC B1882 was not retrieved, fault is intermittent. Go to step  4 .
2. Check right seat belt pretensioner
   
   Turn ignition switch to OFF position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Turn ignition switch to RUN position. Perform on-demand self-test. If DTC B1882 was retrieved during on-demand self-test, go to next step. If DTC B1882 was not retrieved during on-demand self-test, replace right seat belt pretensioner. See SEAT BELT PRETENSIONERS  under REMOVAL & INSTALLATION. Go to step  5 .
3. Check right seat belt pretensioner circuits
   
   Turn ignition switch to OFF position. Access RCM and disconnect connectors. See RESTRAINTS CONTROL MODULE (RCM)  under REMOVAL & INSTALLATION. Measure voltage between ground and RCM harness connector terminals No. 15 (Yellow/Red wire) and No. 16 (Yellow/Black wire) individually. See Figure . If voltage is more than 0.2 volt at either terminal, repair short to battery or ignition in Yellow/Red or Yellow/Black wires. See WIRING DIAGRAMS  . Go to step  5 . If voltage is less than 0.2 volt at both terminals, replace RCM. Go to step  5 .
4. Check for intermittent fault
   
   Refer to continuous DTCs recorded in step  1 . If DTC retrieved in step  1 was an intermittent fault, check for cause of intermittent short to battery or ignition in Yellow/Red or Yellow/Black wires. See WIRING DIAGRAMS  . Attempt to recreate fault by flexing wire harness and cycling ignition switch frequently. Repair any intermittent problems found. Go to next step. If DTC retrieved in step  1 was not an intermittent fault, go to next step.
5. Check for additional DTCs
   
   Refer to continuous DTCs recorded in step  1 . If any continuous DTCs were retrieved, go to diagnostic trouble code identification table for direction to appropriate test. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION  table. DO NOT clear any DTCs until all DTCs have been resolved. If no DTCs were retrieved, reconnect air bag system. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Perform system operation check. See SYSTEM OPERATION CHECK  . Clear all DTCs. See CLEARING FAULT CODES  under DIAGNOSTICS.