LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Supplemental Inflatable Restraint System) >> Diagnostic Tests >> Test P: Air Bag Tone Warning Indicator Circuit Short To Battery Or Ignition (B1891) >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Air bag tone warning indicator circuit shorted to battery or ignition voltage could be caused by short to battery or ignition voltage in Light Blue/Black wire (circuit No. 1083) or damaged or inoperative GEM.

  1. Check for hard or intermittent DTC

    Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). See USING SCAN TOOL  under DIAGNOSTICS. Turn ignition switch to RUN position. Retrieve and record any continuous DTCs. See RETRIEVING FAULT CODES  under DIAGNOSTICS. Perform on-demand self-test. See ON-DEMAND SELF-TEST  under DIAGNOSTICS. If DTC B1891 was retrieved during on-demand self-test, fault is hard. Go to next step. If DTC B1891 was not retrieved, fault is intermittent. Go to step  4 .

  2. Check air bag tone warning indicator circuit

    Turn ignition switch to OFF position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Leave negative battery cable disconnected. Access RCM and disconnect harness connector. See RESTRAINTS CONTROL MODULE (RCM)  under DESCRIPTION & OPERATION. Access GEM and disconnect harness connector C1006. See GENERIC ELECTRONIC MODULE (GEM)  under REMOVAL & INSTALLATION. Turn ignition switch to RUN position. Measure resistance between RCM harness connector terminals No. 26 (Light Blue/Black wire) and No. 2 (Black/Light Green wire, circuit No. 364). If resistance is less than 10 k/ohms, repair short to battery in Light Blue/Black wire and go to step  5 . See WIRING DIAGRAMS  . If resistance is more than 10 k/ohms, go to next step.

  3. Check air bag tone warning indicator

    Turn ignition switch to OFF position. Reconnect negative battery cable. Reconnect GEM connector C1006. Turn ignition to RUN position. Connect fused jumper wire between ground and RCM connector terminal No. 26 (Light Blue/Black wire). Listen for audible warning tone. Allow at least one minute for sequence of tones to sound. If warning tone was heard within one minute, replace RCM. Go to step  5 . If warning tone was not heard within one minute, replace GEM. Go to step  5 .

  4. Check for intermittent fault

    Refer to continuous DTCs recorded in step  1 . If DTC retrieved in step  1 was an intermittent fault, check for cause of intermittent short to battery or ignition voltage in Light Blue/Black wire. See WIRING DIAGRAMS  . Attempt to recreate fault by flexing wire harness and cycling ignition switch frequently. Repair any intermittent problems found. Go to next step. If DTC retrieved in step  1 was not an intermittent fault, go to next step.

  5. Check for additional DTCs

    Refer to continuous DTCs recorded in step  1 . If any continuous DTCs were retrieved, go to diagnostic trouble code identification table for direction to appropriate test. DO NOT clear any DTCs until all DTCs have been resolved. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION  table. If no continuous DTCs were retrieved, reconnect air bag system. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Perform system operation check. See SYSTEM OPERATION CHECK  . Clear all DTCs. See CLEARING FAULT CODES  under DIAGNOSTICS.
scientia non olet · About LEMON Manuals