LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1046 (Bumper System -- F150 Pickup) >> Removal And Installation >> Front Bumper Cover >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

  1. Remove the headlamps. For additional information, REFER to EXTERIOR LIGHTING .
  2. Remove the front bumper cover-to-front bumper bolts.
  3. Remove the hood over-slam bumper bolts.
  4. Remove the hood over-slam bumpers.
  5. Remove the front bumper cover brace bolts.
  6. Remove the front bumper cover braces.
  7. Remove the front bumper cover-to-front fender bolts.
  8. Remove the front bumper cover pin-type retainers.

    Vehicles equipped with wheelhouse lip mouldings 

  9. Remove the 4 retaining nuts.
  10. Remove the fender splash shield pin-type retainers.
  11. Remove the 4 fender splash shield screws.
  12. Position aside the wheelhouse lip mouldings.
    • Disconnect the 6 wheelhouse lip moulding clips.
  13. Release the retaining clips.

    All vehicles 

  14. Remove the bumper cover bolts located at the headlamp openings.
  15. Remove the front bumper cover.
  16. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals