LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Seat System -- F150 Pickup) >> Removal And Installation >> Seat Control Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the power seat switch electrical connector.
    2. NOTE: Recline the seat backrest before removing the recliner handle to ease seat cushion assembly removal.
    Fig 1: Removing Recliner Handle Clip
    G03966173Courtesy of FORD MOTOR CO.
  2. Remove the recliner handle.
    • Release the clip at the rear of side shield by detaching the clip from the metal bracket on the track. Partially flex the side shield at the rear to obtain access to the recliner handle clip. Remove the recliner handle clip (shown removed for clarity) and the recliner handle.
  3. If equipped, remove the lumbar knob.
  4. Remove the power seat knob.
  5. Remove the side shield control panel.
  6. Remove the 2 screws and the seat control switch.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals