Section 1033 (Manual Transmission -- F150 Pickup): Installation: Transmission
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART
| High-Lift Transmission Jack 164-R3508 or equivalent |
MATERIAL CHART
| Item | Specification |
|---|---|
| MERCON® Multi-Purpose ATF Transmission Fluid XT-2-QDX | MERCON® |
- To install, reverse the removal procedure.
- Tighten the stabilizer bar bracket nuts to 48 Nm (35 lb-ft).
NOTE:
Before securing the engine to the transmission, connect the hydraulic line to the clutch slave cylinder.
NOTE:
Make sure the exhaust system is correctly aligned.
NOTE:
Align the index marks when installing the rear driveshaft.
NOTE:
Check and, if necessary, fill the transmission with the specified type and quantity of fluid.