Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 3 push pins and position the air deflector aside.

Fig 1: Removing Push Pins
Courtesy of FORD MOTOR CO.
Using the special tool, disconnect the fluid cooler tubes from the fluid cooler.

Fig 2: Using Special Tool To Disconnect Fluid Cooler Tubes From Fluid Cooler
Courtesy of FORD MOTOR CO.
Remove the 2 bolts and remove the transmission fluid cooler.
- To install, tighten to 15 Nm (11 lb-ft).
Fig 3: Removing Bolts And Removing Transmission Fluid Cooler
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.