LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Controls - Removal, Overhaul & Installation - ECONOLINE - NGV) >> Fuel Systems >> Fuel Rails & Injectors >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Ford Econoline and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air inlet tubes. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Disconnect negative battery cable. Disconnect accelerator cable, accelerator return spring and speed control cable. Disconnect vacuum line from right side of throttle body spacer. Disconnect Idle Air Control (IAC) and Throttle Position (TP) sensor connectors.
  2. Remove throttle body and throttle body spacer. Disconnect injection pressure sensor and fuel temperature sensor electrical connectors. Disconnect right radio capacitor and fuel shut off valve solenoid connectors. Disconnect right fuel injector connectors. Remove the transmission oil filler tube bolts. Remove right side fuel injection supply manifold retaining bolts. Disconnect left fuel injector connectors. Disconnect left radio capacitor connector. Remove left fuel injection supply manifold retaining bolts. Disconnect fuel line. See FUEL LINE FITTINGS . Remove fuel injection supply manifold. Remove fuel injectors.
  3. Install NEW "O" rings with 5W-30 motor oil. To complete installation, reverse removal procedure. Ensure injectors are properly seated. Tighten fuel rail bolts to specification. See TORQUE SPECIFICATIONS .
  4. After installation is completed, pressurize fuel system and inspect fuel lines and fittings for leaks. Perform COMPRESSED NATURAL GAS LEAK TEST under FUEL SYSTEMS in SYSTEM & COMPONENT TESTING - EEC-V - NGV article.
scientia non olet · About LEMON Manuals