LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1029 (Automatic Transmission External Controls -- F150 Pickup) >> Removal And Installation >> Transmission Selector Lever - Column Shift >> Removal

Transmission Selector Lever - Column Shift: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN .
  2. Remove the screw and the lower steering column shroud.
    Fig 1: Removing Screw And Lower Steering Column Shroud
    G03964451Courtesy of FORD MOTOR CO.
  3. Remove the 2 screws and the upper steering column shroud.
    Fig 2: Removing Screws And Upper Steering Column Shroud
    G03964452Courtesy of FORD MOTOR CO.
  4. Disconnect the overdrive cancel switch electrical connector.
    Fig 3: Disconnecting Overdrive Cancel Switch Electrical Connector
    G03928984Courtesy of FORD MOTOR CO.
  5. Remove the retaining screw and remove the shift lever.
    Fig 4: Removing Retaining Screw And Removing Shift Lever
    G03964486Courtesy of FORD MOTOR CO.