LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1027 (Engine Ignition System - 4.6L (2V) -- F150 Pickup) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the ignition coil electrical connector.
  3. Remove the ignition coil retaining bolt.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Rotate the ignition coil clockwise 30-40 degrees to clear the fuel injection supply manifold. Use a twisting motion while pulling up on the ignition coil and remove.
    5. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
  5. To install, reverse the removal procedure.
    • Apply dielectric compound to the inside of the coil boots before installing.
scientia non olet · About LEMON Manuals