Powertrain Control Module (PCM) Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
POWERTRAIN CONTROL MODULE DIAGNOSTIC TROUBLE CODE INDEX
| DTC | Description | Source | Action |
|---|---|---|---|
| B1213 | Anti-Theft Number of Programmed Keys is Below Minimum | PCM | GO to PINPOINT TEST B . |
| B1342 | ECU is Defective | PCM | INSTALL a new PCM. REFER to ELECTRONIC ENGINE CONTROLS . |
| B1600 | PATS Key Transponder Signal is Not Received - Damaged Key or Non-PATS Key | PCM | GO to PINPOINT TEST D . |
| B1601 | PATS Received Incorrect Key-Code From Key Transponder (Unprogrammed PATS Key) | PCM | GO to PINPOINT TEST E . |
| B1602 | PATS Received Invalid Format of Key-Code From Key Transponder (Partial Key Read) | PCM | GO to PINPOINT TEST F . |
| B1681 | PATS Transceiver Module Signal is Not Received (Damaged, Not Connected, or Damaged Wiring) | PCM | GO to PINPOINT TEST G . |
| B2103 | Internal Transceiver Antenna Damaged | PCM | GO to PINPOINT TEST C . |
| B2431 | Key Program Failure | PCM | GO to PINPOINT TEST F . |
| P1260 | PCM Disabled-Vehicle Disabled | PCM | REPAIR the PCM. REFER to the INTRODUCTION - GASOLINE article . |