LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Engine Ignition System - 5.4L (3V) -- F150 Pickup) >> Removal And Installation >> Spark Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition coil-on-plug. For additional information, refer to IGNITION COIL-ON-PLUG .
    2. NOTE: Use compressed air to remove any foreign material from the spark plug well before removing the spark plugs.
    NOTE: If an original spark plug is used, make sure it is installed in the same cylinder from which it was taken. New spark plugs can be used in any cylinder.
  2. Remove the spark plugs.
    • To install, tighten to 34 Nm (25 lb-ft).
    3. CAUTION: The spark plug gap is NOT adjustable. Damage can occur to the ceramic if the gap is adjusted. Replace the spark plug if the gap is out of specification.
  3. Inspect the spark plugs. Install new spark plugs as necessary. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals