LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Engine Ignition System - 5.4L (3V) -- F150 Pickup) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the ignition coil electrical connector.
  3. Remove the bolt and the ignition coil.
    • Remove the ignition coil. Use a twisting motion while pulling up on the ignition coil.
    • To install, tighten to 6 Nm (53 lb-in).
    4. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
  4. To install, reverse the removal procedure.
    • Apply a light coat of dielectric compound to the inside of the ignition coil boots.
scientia non olet · About LEMON Manuals