LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1022 (Engine Ignition System - 4.2L -- F150 Pickup) >> Removal And Installation >> Ignition Coil >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ignition coil electrical connector.
    2. CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wires.
    CAUTION: The spark plug wires must be connected in the correct firing order.
  2. Disconnect the spark plug wires from the ignition coil by twisting while pulling upward.
  3. Remove the bolts and the ignition coil.
    • To install, tighten to 6 Nm (53 lb-in).
  4. Inspect the ignition coil for carbon tracks or damage.
  5. To install, reverse the removal procedure.
    • Apply silicone brake caliper grease and dielectric compound to the inside of the spark plug wire boots.
scientia non olet · About LEMON Manuals