| - |
Continuous |
The Air Bag Warning Indicator is Illuminated Continuously - RCM Disconnected or Inoperative, Loss of Battery Feed or Loss of Signal Ground |
GO to PINPOINT TEST A . |
| B1231 |
13 |
Crash Data Memory Full |
Install a new RCM and impact sensor. REFER to INSPECTION AND REPAIR After a Supplemental Restraint System SRS Deployment. |
| B1317 |
Continuous |
Battery Voltage High |
CHECK battery voltage. Should be below 16 volts. REFER to CHARGING SYSTEM - GENERAL INFORMATION
. |
| B1318 |
Continuous |
Battery Voltage Low |
CHECK battery voltage. Should be above 9.0 volts. REFER to CHARGING SYSTEM - GENERAL INFORMATION
. |
| B1342 |
12 |
RCM Is Faulted |
Install a new RCM. REFER to RESTRAINTS CONTROL MODULE RCM . |
| B1869 |
NONE Continuous lamp Secondary air bag warning sounds if another fault is present |
Air Bag Warning Indicator Circuit Open or Short to Ground |
GO to PINPOINT TEST B . |
| B1870 |
NONE Secondary air bag warning sounds if another fault is present |
Air Bag Warning Indicator Circuit Short to Battery |
GO to PINPOINT TEST C . |
| B1884 |
18 |
PAD Warning Lamp Circuit Failure |
GO to PINPOINT TEST D . |
| B1890 |
18 |
PAD Warning Lamp Circuit Short to Battery |
GO to PINPOINT TEST E . |
| B1891 |
53 |
Air Bag Tone Warning Indicator Circuit Short to Battery |
GO to PINPOINT TEST F . |
| B1892 |
53 |
Air Bag Tone Warning Indicator Circuit Short to Ground or Open |
GO to PINPOINT TEST G . |
| B1921 |
14 |
Air Bag Diagnostic Monitor Ground Circuit Open |
GO to PINPOINT TEST H . |
| B2290 |
16 |
Occupant Classification System Fault |
GO to PINPOINT TEST I . |
| B2292 |
33 |
Restraint System - Safety Belt Pretensioner Fault (Driver Pretensioner Circuit Fault) |
GO to PINPOINT TEST J . |
| B2292 |
34 |
Restraint System - Safety Belt Pretensioner Fault (Passenger Pretensioner Circuit Fault) |
GO to PINPOINT TEST J . |
| B2293 |
19 |
Restraint System - Air Bag Fault (Driver Front Air Bag Circuit Fault) |
GO to PINPOINT TEST K . |
| B2293 |
21 |
Restraint System - Air Bag Fault (Passenger Front Air Bag Circuit Fault) |
GO to PINPOINT TEST K . |
| B2296 |
42 |
Restraint System - Impact Sensor Fault (Front Impact Severity Sensor Circuit Fault) |
GO to PINPOINT TEST L . |
| B2434 |
51 |
Driver Safety Belt Buckle Switch Circuit Short to Ground |
GO to PINPOINT TEST M . |
| B2435 |
51 |
Driver Safety Belt Buckle Switch Circuit Resistance Out of Range |
GO to PINPOINT TEST N . |
| B2438 |
52 |
Passenger Safety Belt Buckle Switch Circuit Short to Ground |
GO to PINPOINT TEST O . |
| B2439 |
52 |
Passenger Safety Belt Buckle Switch Circuit Resistance Out of Range |
GO to PINPOINT TEST P . |
| B2477 |
Continuous |
Module Configuration Error |
INSTALL a new RCM. |
| B2691 |
51 |
Driver Safety Belt Buckle Switch Circuit Fault |
GO to PINPOINT TEST Q . |
| B2692 |
52 |
Passenger Safety Belt Buckle Switch Circuit Fault |
GO to PINPOINT TEST R . |
| B2909 |
16 |
Belt Tension Sensor Fault |
GO to PINPOINT TEST S . |
| C1414 |
15 |
Incorrect Module Design Level |
GO to PINPOINT TEST T . |
| C1947 |
49 |
Driver Seat Track Position Sensor Circuit Short to Ground |
GO to PINPOINT TEST U . |
| C1948 |
49 |
Driver Seat Track Position Sensor Circuit Resistance Out of Range |
GO to PINPOINT TEST V . |
| C1981 |
49 |
Driver Seat Track Position Sensor Circuit Fault |
GO to PINPOINT TEST W . |
| - |
- |
No Communication with the Restraints Control Module. |
GO to PINPOINT TEST X . |