Parking Brake Cable Tension Release
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Release the parking brake.
- With the vehicle in NEUTRAL, position it on the hoist. For additional information, refer to JACKING & LIFTING .
- With an assistant, release the parking brake cable tension by pulling down on the intermediate cable at the cable-to-cable union until the parking brake control sector rotates to its stop and a 4 mm (0.15 in) x 150 mm (5.9 in) retainer pin can be inserted.
- Disconnect the cable at the cable-to-cable union.