LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Fuel Injection Supply Manifold & Injectors >> Removal (4.6L SOHC - VIN W, X & 9)

Removal (4.6L SOHC - VIN W, X & 9)

  1. Ensure ignition switch is turned to OFF position. Remove air inlet tube. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Disconnect negative battery cable. Disconnect fuel supply line. See FUEL LINE CONNECTOR . Remove throttle body. See THROTTLE BODY .
  2. Remove Idle Air Control (IAC) valve hose and position aside. Remove Positive Crankcase Ventilation (PCV) hose. Disconnect 4 right side fuel injector electrical connectors. Disconnect IAC electrical connector and main chassis vacuum hose. Remove accelerator and cruise control cable (if equipped) and position aside.
  3. Disconnect electrical connector and vacuum hose at fuel pressure sensor. Disconnect ground wire electrical connector located at rear left side of intake manifold. Disconnect 4 left side fuel injector connectors. Remove Exhaust Vacuum Regulator (EVR) solenoid vacuum hoses.
  4. Remove 2 bolts retaining Exhaust Gas Recirculation (EGR) pressure transducer bracket and position aside. Remove EGR-to-exhaust manifold tube. Remove vacuum hose at EGR valve. Remove 4 fuel injection supply manifold bolts. Remove fuel injection supply manifold and injectors as a unit. Remove fuel injectors and discard "O" rings.
scientia non olet · About LEMON Manuals