LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.0L Inline - VIN B & 3 >> Removal & Installation >> Water Pump >> Removal & Installation (Escape)

Removal & Installation (Escape)

  1. Drain the engine cooling system.
  2. Remove the right front tire assembly.
  3. Remove the splash shield.
    Fig 1: Removing Splash Shield
    G03430677Courtesy of FORD MOTOR CO.
  4. Remove the accessory drive belt.
  5. Remove the coolant pump pulley.
    Fig 2: Removing Coolant Pump Pulley
    G03430678Courtesy of FORD MOTOR CO.
  6. Remove the four bolts and the coolant pump.
    Fig 3: Removing Four Bolts & Coolant Pump
    G03430679Courtesy of FORD MOTOR CO.
    7. NOTE: Clean and inspect the sealing surfaces.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals