LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.0L Inline - VIN B & 3 >> Removal & Installation >> Thermostat >> Removal and Installation (Escape)

Removal and Installation (Escape)

  1. Partially drain the engine coolant.
  2. Remove the three bolts and separate the coolant outlet adapter from the thermostat housing.
    Fig 1: Removing Coolant Outlet Adapter From Thermostat Housing
    G01390211Courtesy of FORD MOTOR CO.
    3. NOTE: The thermostat is indexed and must be installed correctly.
    Fig 2: Removing Thermostat & O-Ring Seal
    G01390212Courtesy of FORD MOTOR CO.
  3. Remove the thermostat and the O-ring seal.
    4. NOTE: Clean and inspect the sealing surfaces.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals