LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.0L Inline - VIN B & 3 >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. To install, reverse removal procedure. Ensure crankshaft timing marks are aligned. See Figure. Use Camshaft Alignment Timing Tool (T94P-6256-CH) to ensure alignment of camshafts. Install tool in slots on camshafts at rear of engine. Position NEW cylinder head gasket on cylinder block.
  2. Install cylinder head using NEW cylinder head bolts. Tighten bolts in sequence to specification. See Fig 1 . See TORQUE SPECIFICATIONS .
    Fig 1: Cylinder Head Bolt Tightening Sequence
    G99F04350Courtesy of FORD MOTOR CO.
  3. Install camshafts. See CAMSHAFT . Install timing belt. See TIMING BELT . To complete installation, reverse removal procedure. Tighten remaining bolts to specification. See TORQUE SPECIFICATIONS . Fill or top off fluids. Start engine and check for leaks.
scientia non olet · About LEMON Manuals