Test W: Abs Light Inoperative
Turn ignition switch to LOCK position. Disconnect instrument cluster harness connector C808A. Disconnect ABS module harness connector C3002. Measure resistance of Black/Red wire between terminal No. 25 at ABS module harness connector C3002 and terminal No. 2 at instrument cluster harness connector C808A. See Figure and Fig 1 . If resistance is more than 5 ohms, repair open in Black/Red wire. If resistance is 5 ohms or less, inspect ABS indicator bulb and replace as necessary. If bulb is okay, check instrument cluster printed circuit ANTI-LOCK article in BRAKES.