LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> System Tests >> Test R: High Beam Indicator Inoperative

Test R: High Beam Indicator Inoperative

  1. Turn ignition switch to RUN position. Turn headlights on. Place multifunction switch to high beam position. If high beam headlights are on, go to next step. If high beam headlights are not on, locate and repair problem in headlight system. See HEADLIGHT SYSTEMS article.
  2. Turn ignition switch to LOCK position. Disconnect instrument cluster harness connector C808A. Disconnect right headlight harness connector C834B. Measure resistance in Orange/White wire between terminal No. 5 at instrument cluster harness connector C808A and right headlight harness connector C834B. See Figure . If resistance is 5 ohms or less, inspect high beam indicator bulb and replace as necessary. If bulb is okay, replace instrument cluster printed circuit. If resistance is more than 5 ohms, repair open in Orange/White wire.
scientia non olet · About LEMON Manuals