LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 2.0L Inline - VIN B & 3 >> Overhaul >> Cylinder Block Assembly >> Fitting Pistons

Fitting Pistons

To determine if piston-to-cylinder clearance is within specification, measure piston skirt diameter at 90-degree angle to piston pin. Measure piston diameter 1.62" (42 mm) from top of piston. See PISTONS, PINS & RINGS  table under ENGINE SPECIFICATIONS. Pistons are available in .010" (.25 mm) and .020" (.50 mm) oversize.

scientia non olet · About LEMON Manuals