LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft Systems - Active >> Component Tests >> Relays >> Panic Alarm Headlight Relay & Panic Alarm Brakelight Relay

Panic Alarm Headlight Relay & Panic Alarm Brakelight Relay

  1. Remove relay to be tested. Measure resistance between terminal No. 5 and all other terminals. Resistance should be greater than 5 ohms. Measure resistance between terminals No. 3 and 4. Resistance should be less than 5 ohms. See Fig 1 . If resistances are as specified, go to next step. If resistances are not as specified, replace relay.
  2. Using fused jumper wires, connect positive battery voltage to terminal No. 1 and ground terminal No. 2. With voltage applied, resistance between terminals No. 3 and 5 should be 5 ohms or less and resistance between terminals No. 3 and 4 should be greater than 5 ohms. If resistances are as specified, relay is okay at this time. If resistances are not as specified, replace relay.
Fig 1: Identifying Panic Alarm Headlight Relay & Panic Alarm Brakelight Relay Terminals
G97J28141Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals