Removal & Installation (Column Shift)
CAUTION:
DO NOT use excessive force when installing radio removers. Excessive force will damage retaining clips and make control panel removal difficult.
- Disconnect negative battery cable. Tilt steering column to lowest position. Remove upper and lower steering column covers. Remove instrument cluster finish panel. Using Radio Removing Tool (T87P-19061-A) into integrated control panel face plate. Push removers in about 1.5" to release retaining clips. Disconnect integrated control panel harness connectors and remove integrated control panel.
- Remove instrument cluster retaining screws. Disconnect transmission range indicator cable from column selector tube. Pull top part of instrument cluster toward steering wheel. Disconnect instrument cluster harness connectors. Remove instrument cluster. To install, reverse removal procedure.