Test W: Abs Light Inoperative
Turn ignition switch to LOCK position. Disconnect instrument cluster harness connector C808A. Disconnect ABS module harness connector C3002. Measure resistance in Black/Red wire between terminal No. 25 at ABS module harness connector C3002 and terminal No. 2 at instrument cluster harness connector C808A. See Figure and Fig 1 . If resistance is greater than 5 ohms, repair open in Black/Red wire. If resistance is 5 ohms or less, inspect ABS indicator bulb and replace as necessary. If bulb is okay, check instrument cluster printed circuit and replace as necessary. If printed circuit is okay, repair ABS concern. See appropriate ANTI-LOCK article in BRAKES.