LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1999 >> Contour SVT >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panels - Analog >> System Tests >> Test P: Speedometer Inaccurate

Test P: Speedometer Inaccurate

  1. Turn ignition switch to LOCK position. Connect NGS tester to Data Link Connector (DLC). Using NGS tester, monitor PCM PID VSS(+). Start vehicle. Test driver vehicle and compare PID value on NGS tester to speedometer. If speeds do not match, go to next step. If speeds match, system is okay at this time.
  2. Turn ignition switch to LOCK position. Disconnect vehicle speed sensor harness connector C903 (C1899 on M/T). Measure resistance between ground and terminal No. 2 (White/Blue wire) at vehicle speed sensor harness connector. See Figure . If resistance is greater than 10 k/ohms, repair or replace instrument cluster as necessary. If resistance is 10 k/ohms or less, repair short to ground in White/Blue wire between vehicle speed sensor and instrument cluster and/or short to ground in White/Violet wire between PCM and splice S60. See WIRING DIAGRAMS  .
scientia non olet · About LEMON Manuals