LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 563 (Parking Brake System & Actuation -- F250-F550 Super Duty) >> Diagnosis And Testing >> Parking Brake >> Pinpoint Tests >> Pinpoint Test B: The Parking Brake Will Not Release >> Pinpoint Test B: The Parking Brake Will Not Release

Pinpoint Test B: The Parking Brake Will Not Release

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. B1 CHECK THE PARKING BRAKE CONTROL RELEASE HANDLE AND CABLE 
    • Verify that the release handle and cable are connected to the parking brake control.
    • Are the release handle and cable connected? 

    Yes  : GO to B2.

    No  : CONNECT the handle and cable, then TEST the system for normal operation.

  2. B2 CHECK THE REAR PARKING BRAKE CABLES 
    • Disconnect the RH cable from the LH conduit equalizer, then disconnect the LH cable from the front cable.
      Fig 1: Locating RH Cable From LH Conduit Equalizer
      G04644527Courtesy of FORD MOTOR CO.
    • Release the rear parking brake cables from the bracket assembly.
      Fig 2: Locating Parking Brake Cable At LH Bracket Assembly
      G03919405Courtesy of FORD MOTOR CO.
    • Rotate the rear parking brake cables 90 degrees to release them from the parking brake actuating levers.
      Fig 3: Locating Parking Brake Actuating Levers
      G03919392Courtesy of FORD MOTOR CO.
    • While holding the rear cable conduit, attempt to slide the rear cable inside the conduit.
    • Does the cable slide freely inside the conduit? 

    Yes  : GO to B3.

    No  : INSTALL a new rear cable. REFER to PARKING BRAKE CABLE - LH  or PARKING BRAKE CABLE - RH  in this section. TEST the system for normal operation.

  3. B3 CHECK THE REAR PARKING BRAKE SHOES AND HARDWARE 
    • Remove the rear brake disc, refer to REAR DISC BRAKE .
    • Inspect the parking brake shoes, hardware and backing plate.
    • Are the shoes, hardware and backing plate in good condition? 

    Yes  : GO to B4.

    No  : INSTALL new components as necessary. TEST the system for normal operation.

  4. B4 ISOLATE THE FRONT PARKING BRAKE CABLE 

Yes  : INSTALL a new parking brake control. REFER to PARKING BRAKE CONTROL  in this section. TEST the system for normal operation.

No  : INSTALL a new front cable. TEST the system for normal operation.