LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panels - Analog >> Testing >> Warning Indicators Inoperative

Warning Indicators Inoperative

  1. Turn ignition off. Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Turn ignition on. Using a voltmeter, check for battery voltage at cluster connector C250 terminals No. 16 (Red/Yellow wire) and No. 7 (Red/Yellow wire) and cluster connector C251 terminal No. 4 (Red/Yellow wire). If battery voltage is present, go to next step. If battery voltage is not present, repair Red/Yellow wire in question for open and retest system.
  2. Turn ignition off. Measure resistance between instrument cluster connector C251 terminal No. 10 (Red/Yellow wire) and each indicator lamp socket. If resistance is one ohm or less, go to next step. If resistance is more than one ohm, replace instrument cluster printed circuit and retest system. See PRINTED CIRCUIT under REMOVAL & INSTALLATION.
  3. Remove indicator light bulbs. Using an ohmmeter, check resistance of each bulb. If resistance of each bulb is 5 ohms or less, repair indicator control device on affected circuit(s). If resistance of any bulb is more than 5 ohms, replace bulb in question and retest system.
scientia non olet · About LEMON Manuals