LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cables. Partially drain cooling system. Remove upper radiator hose. Disconnect coolant recovery hose from radiator.
    CAUTION: Fan clutch assembly uses right-hand threads to hold assembly onto water pump.
  2. Using Fan Clutch Holder (T94T-6312-AH) and Fan Clutch Nut Wrench (T83T-6312-B), remove fan and fan clutch assembly from water pump. Place fan and fan clutch assembly in fan shroud. Remove bolts, fan shroud along with fan and fan clutch assembly.
  3. Loosen water pump pulley bolts. Note direction of accessory drive belt routing for installation reference. Rotate accessory drive belt tensioner away from accessory drive belt. Remove accessory drive belt.
  4. Remove bolts and water pump pulley. Disconnect necessary electrical connectors and coolant hoses for removal of water pump. Note water pump bolt location for installation reference. Remove bolts, water pump and gasket.
scientia non olet · About LEMON Manuals