LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Oil Pan >> Installation

Oil Pan: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using NEW gasket, install oil pump pick-up tube if removed. Install and tighten oil pump pick-up tube-to-front cover bolts and oil pump pick-up tube support bracket nut at top of main bearing cap to specification. See TORQUE SPECIFICATIONS .
  2. Apply a 1/8" (3.2 mm) bead of RTV sealant onto sealing surfaces on sides of oil pan with sealant located on inside of bolt holes. Apply a 1/4" (6.35 mm) bead of RTV sealant onto oil pan sealing surfaces at front and rear of oil pan.
  3. Install oil pan using guide studs. Ensure all oil pan bolts are installed before tightening. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals