Fuel Pump: Installation
WARNING: This page is about a different variant/trim than selected.
- To install, reverse removal procedure using NEW "O" ring on fuel pump and seal rings on banjo bolt and fuel line assembly. Rotate engine until camshaft lobe for fuel pump is on base circle and lobe is facing away from fuel pump before installing fuel pump. Ensure fuel pump bolts are tightened evenly to prevent damage to fuel pump.
- When installing fuel line assembly, ensure fuel line assembly-to-fuel pump banjo bolt and fuel line assembly-to-cylinder head fittings are all loosely installed before tightening banjo bolt to specification. Tighten fuel line assembly-to-fuel pump banjo bolt to specification. See TORQUE SPECIFICATIONS .