Removal (Spring Lock Coupling)
WARNING: This page is about a different variant/trim than selected.
- Relieve fuel pressure. See RELIEVING FUEL PRESSURE . Remove retaining clip from spring lock coupling. See Figure. DO NOT use screwdriver or sharp object when removing retaining clip, as spring lock coupling may be damaged.
- Twist both fuel lines to release seal adhesion on "O" rings. Spring Lock Coupling Remover (T81P-19623-G1 for 3/8" fuel line) or (T81P-19623-G2 for 1/2" fuel line) is used to release spring lock coupling.
- Install spring lock coupling remover ontospring lock coupling so spring lock coupling remover enters cage opening ontospring lock coupling. See Figure. This allows garter spring in spring lock coupling to be released.
- Push spring lock coupling remover into cage opening to release female fitting ontofuel line from garter spring in spring lock coupling. Pull fuel lines apart. Remove spring lock coupling remover.