LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Exhaust Manifold >> Removal (Van)

Removal (Van)

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cables. Remove interior engine cover. Drain cooling system. When removing passenger's side exhaust manifold, remove air cleaner assembly. Remove oil level indicator tube and retaining nut.
  2. Remove upper radiator hose and coolant recovery hose. Using Fan Clutch Holder (T94T-6312-AH) and Fan Clutch Nut Wrench (T83T-6312-B), remove fan and fan clutch assembly from water pump. Place fan and fan clutch assembly in fan shroud. Remove fan shroud. Remove drive belt. Remove generator.
  3. On all applications, raise and support vehicle. Remove exhaust inlet pipe-to-exhaust manifold bolt/nuts. Exhaust inlet pipe fits between exhaust manifold and exhaust inlet adapter on turbocharger. On right side, disconnect exhaust backpressure line from manifold. On both sides, remove bolts and exhaust manifold.
scientia non olet · About LEMON Manuals