LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Cylinder Head >> Installation (Van)

Installation (Van)

WARNING: This page is about a different variant/trim than selected.
  1. Ensure fuel and oil are removed from cylinders before installing cylinder head. To install, reverse removal procedure using NEW cylinder head gasket. Lightly coat threads of cylinder head bolts with engine oil before installing.
    CAUTION: DO NOT apply excessive amount of engine oil onto threads of cylinder head bolts or threads and/or sealing surfaces may be damaged. DO NOT use any other lubricants on threads of cylinder head bolts except engine oil.
  2. Install and tighten cylinder head bolts to specification in 3 steps. See Figure. See TORQUE SPECIFICATIONS .
  3. To install remaining components, reverse removal procedure. Install fuel injectors using proper procedure. See FUEL INJECTOR .
  4. Ensure proper procedure is used when installing rocker arm assemblies and push rods. See ROCKER ARM ASSEMBLY & PUSH ROD .
  5. Adjust all fluid levels. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING . On A/C equipped models, evacuate and recharge A/C system.
scientia non olet · About LEMON Manuals