Crankshaft Rear Oil Seal: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove transmission. See appropriate article in CLUTCHES. On M/T models, remove flywheel. See FLYWHEEL . On A/T models, remove bolts, spacer and flexplate. On all models, remove flywheel adapter housing retaining rings. Remove flywheel front adapter, using care not to damage alignment dowel pins.
- Remove crankshaft rear oil seal retaining bolts from rear of cylinder block. Remove crankshaft rear oil seal. Remove engine rear cover retaining bolts and rear cover. Clean cover sealing surfaces. Clean crankshaft rear oil seal surfaces. If equipped with crankshaft wear sleeve, remove crankshaft wear sleeve using Crankshaft Service Set (T94T-6701-AH) and Handle (T80T-4000-W).