LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Ensure sealing surfaces are clean and all silicone sealant is removed. Apply silicone sealant onto engine rear cover sealing surface. Install rear engine cover. Apply silicone sealant onto crankshaft rear oil seal retaining ring and threads of crankshaft rear oil seal retaining bolts.
  2. Using Crankshaft Seal Replacer (T94T-6701-AH3), Crankshaft Seal Replacer (T94T-6701-AH4), Handle (T80T-4000-W) and guide pins, install crankshaft wear ring (if equipped) and crankshaft rear oil seal.
  3. Install and tighten crankshaft rear oil seal retaining bolts. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals