LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Camshaft Bearings >> Removal

Camshaft Bearings: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove camshaft from cylinder block. See CAMSHAFT . Remove flywheel. See FLYWHEEL .
  2. Remove crankshaft with pistons and connecting rods remaining in cylinder block. See CRANKSHAFT & MAIN BEARINGS  under CYLINDER BLOCK ASSEMBLY under OVERHAUL.
    CAUTION: Place protective tubing onto connecting rod bolts to prevent damaging crankshaft during crankshaft removal and installation. Push pistons upward toward top of cylinder bore when servicing camshaft bearings. DO NOT allow piston to contact piston cooling oil jets when pushing piston into top of cylinder bore.
  3. Push piston upward toward top of cylinder bore. Use care not to damage piston cooling oil jets when pushing piston upward in cylinder bore. Using Camshaft Bearing Remover/Installer (T65L-6250-A), remove camshaft bearings from cylinder block.
scientia non olet · About LEMON Manuals