LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Removal & Installation >> Camshaft Bearings >> Installation

Camshaft Bearings: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse removal procedure. Ensure oil hole in camshaft bearing aligns with oil hole in cylinder block.
    CAUTION: Install front camshaft bearing to specified installed depth to prevent damage to engine components.
  2. Install front camshaft bearing in cylinder block so front camshaft bearing installed depth is .020-.050" (.51-1.27 mm). Front camshaft bearing installed depth is measured from face of cylinder block to front edge of front camshaft bearing. Install NEW cylinder block camshaft core plug. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals