Cylinder Block Specifications

WARNING: This page is about a different variant/trim than selected.

CYLINDER BLOCK

Application

In. (mm)

Cylinder Bore

Standard Diameter

4.1096-4.1103 (104.384-104.402)

Maximum Taper

.003 (.076)

Maximum Out-Of-Round

.0002 (.051)

Maximum Deck Warpage

⁽¹⁾

⁽¹⁾	Warpage should not exceed .0030" (.076 mm) within a 6.0" (152 mm) area or .0060" (.152 mm) overall. Cylinder block may be resurfaced. DO NOT remove more than .010" (.25 mm) of material from cylinder block if resurfacing cylinder block.