LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Engine Oiling >> Oil Cooler Assembly >> Installation

Oil Cooler Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using NEW gaskets, install oil cooler assembly onto cylinder block. Install and tighten oil cooler rear header-to-cylinder block bolts until bolts are snug. Install and tighten oil cooler front header-to-cylinder block bolts to specification. See TORQUE SPECIFICATIONS .
  2. Lower engine. Install driver's side engine mount. Tighten oil cooler rear header-to-cylinder block bolts to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure. Adjust engine oil level. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under REMOVAL & INSTALLATION.
NOTE: If engine oil leaked into cooling system due to defective oil cooler, drain and flush cooling system as necessary. If coolant leaked into crankcase due to defective oil cooler, change engine oil and oil filter.
Fig 1: Exploded View Of Oil Cooler Assembly
G97E03802Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals