LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Econoline XLT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F) >> Engine Oiling >> Low-Pressure Oil Pump >> Reassembly & Installation

Reassembly & Installation

WARNING: This page is about a different variant/trim than selected.
  1. To reassemble, reverse disassembly procedure. Ensure components are installed in original location.
  2. To install, reverse removal procedure using "O" ring. Ensure outer gerotor is lubricated with engine oil before installing low-pressure oil pump body. Install and tighten low-pressure oil pump body-to-front cover bolts.
  3. Manufacturer recommends installing NEW crankshaft front seal any time vibration damper is removed. For proper installation procedure of crankshaft front seal, see CRANKSHAFT FRONT SEAL  under REMOVAL & INSTALLATION.
Fig 1: Locating Low-Pressure Oil Pump Components
G97C03801Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals